Configuration Fault

Configuration fault

Checking for permanent or intermittent faults
Check to see if any symptoms reported by the customer remain.

Are any symptoms reported by the customer still present?

Yes - Information

No - Intermittent fault

-------------------------------------------------

Information
The control module has registered a software fault. The software does not correspond to the other configurations in the car.
A possible cause of the fault is that a used control module has been installed in the car. If this is the case, the cause of the fault has probably been discovered.
New software, corresponding to the configuration of the rest of the car, can be downloaded after consultation with the customer.

Continue - DONE

-------------------------------------------------

Intermittent fault
The control module previously registered a software fault. The software did not correspond to the configuration of the rest of the car. The control module has detected that the fault is no longer present.

Continue - FAULT FOUND

-------------------------------------------------