Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking wiring / back-up (reversing) light switch
Check the cable between the central electronic module (CEM) terminal #1A and the back-up (reversing) lamp switch terminal #2 (3/10). Check for an intermittent short-circuit to ground.
Also check the back-up (reversing) lamp switch. Check for an intermittent short-circuit to ground.
Remedy as necessary.

Other information:
- For information about the central electronic module (CEM), see Central electronic module (CEM), replacing Service and Repair
- To access the back-up (reversing) lamp switch, see Back-up lamp switch, replacing .













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

------------------------

Attempt New Test - Checking wiring / back-up (reversing) light switch

-------------------------------------------------