Signal Missing

Signal missing

Checking components and wiring








- Ignition off
- Disconnect the connector for the loudspeaker in the right front door.
Check the cable terminals. Check for contact resistance, loose connections and oxidation.

Note! Only visually check the treble loudspeaker for oxidation and loose connections. Do not carry out any electrical fault-tracing on the treble loudspeaker.

Check the cable terminals in the female and male sections of the connector. The cable terminals must not be damaged or pressed back.
Check the signal cable between audio module (AUD) terminal #B3 and loudspeaker terminal #2 in the right front door. Check for an open-circuit.
Check the signal cable between audio module (AUD) terminal #B11 and loudspeaker terminal #1 in the right front door. Check for an open-circuit.
Check loudspeaker connector terminals #1 and #2 in the right front door. Check for an open-circuit.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Audio Module (AUD)
- To access or replace the audio module (AUD), see Audio module (AUD), replacing Audio Module (AUD), Replacing
- To access and replace the loudspeaker in the front side door, see Loudspeaker, front side door, replacing Loudspeaker, Front Side Door, Replacing
- For information about signals, see Signal specification Signal Specification, Audio Module (AUM)
- Checking wiring and terminals Checking Wiring and Terminals.













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that sound can be heard from the loudspeakers from the Audio module (AUD) by trying the radio FM/AM, CD or MD player.

Do the loudspeakers work?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------