Checking Antenna Cable From GPS Antenna

Checking antenna cable from GPS antenna

Check, connectors and cables
Check the control module input connector for the GPS antenna signal cable and GPS antenna connector for contact resistance and oxidation according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Check cable between control module and GPS antenna for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault , a short-circuit to ground according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault and a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.

Other information:
- To access/replace the control module, see Replacing the control module, old system Replacing the Control Module, Old System.
- To access/replace the GPS antenna, see Replacing GPS antenna Removal and Replacement.













Was a fault detected?

Yes - FAULT FOUND

No - No Fault Found

-------------------------------------------------