Mud Guards, Front

Mudguard front

- Remove the front wheels
- Clean the area at the rear edge of the wing liner and the edge of the wing where the mudguard will be positioned
- Carefully drill out the three rivets holding the wing liner at the rear edge of the front wing. Use a 6 mm (1/4") diameter drill bit
- Remove any rivet swarf.

Note! Do not damage any of the plastic components.

- Install the mudguard. Rivet the mudguard into place in the wing liner and the rear edge of the front wing
- Reinstall the front wheels. Tighten the wheels. Tighten to 140 Nm (103 lbf. ft).