Checking the Central Locking Switch

Checking the central locking switch

Checking fuses




- Ignition off
- Check that fuse 11C/35 (if driver door module (DDM) is on the left) or 11C/36 (if driver door module (DDM) is on the right) in the passenger compartment fusebox is intact.

Other information:
- For further information about the fuses and relays, see the Wiring Diagram.





Was a fault detected?

Yes - Fault Found

No - Replacing the component

-------------------------------------------------

Replacing the component
The driver/passenger door module (DDM/PDM) has registered an internal fault.

Caution! A new control module is delivered without software. The control module must be programmed when it has been replaced.

After replacing the control module the window position must be initialized.
Move the window to its upper limit position using manual control.
Initialize the window.
From model year 2003 inclusive, the window will lower approximately 10 centimeters and then close again during initialization.

Other information:
- For information about programming and replacing the driver/passenger door module (DDM/PDM), see Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing.





Continue - Fault Found

-------------------------------------------------