Checking the Tailgate Wiper
Checking the tailgate wiper
Checking components
Activate the tailgate wiper using the wiper switch. Read off the status.
Hint: If the wiper switch status is OK, the fault is not in the steering wheel module (SWM).
Was the tailgate wiper status OK?
Yes - No Fault Found
No - Replacing components
-------------------------------------------------
Replacing components
Check the tailgate wiper fuse; replace as necessary.
Replace relay 2/16.
Other information:
- For further information about the fuses and relays, see the Wiring Diagram
- To access the relay/fuse box in the cargo compartment: Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
Select "Continue" when the fault has been remedied.
Continue - Checking components
-------------------------------------------------
Checking components
Activate the tailgate wiper. Read off the status.
Hint: If the readout of tailgate wiper status was OK, the fault was caused by a damaged fuse or relay. The fuse can blow if relays are activated in the wrong order. This can happen when the key is turned from position I to position II and the wiper arm is activated at the same time.
Was the tailgate wiper status OK?
Yes - Fault Found
No - Replacing the component
-------------------------------------------------
Replacing the component
Replace the wiper switch.
Other information:
- For replacing the wiper switch: Washer / wiper switch, replacing Service and Repair
Select "Continue" when the fault has been remedied.
Continue - Checking components
-------------------------------------------------
Checking components
Activate the tailgate wiper. Read off the status.
Hint: If the tailgate wiper switch status is OK the fault is in the tailgate wiper.
Was the tailgate wiper status OK?
Yes - Fault Found
No - Replacing the component
-------------------------------------------------
Replacing the component
Try replacing the steering wheel module (SWM).
Caution! A new control module is delivered without software. The control module must be programmed in order to function after replacement.
Other information:
- For replacing and programming and replacing the control module: Steering wheel module (SWM), replacing Service and Repair
Was a fault detected?
Yes - Fault Found
No - No Fault Found
-------------------------------------------------