Camshaft Position Sensor: Service and Repair

Replacing the camshaft position sensor (CMP)

Removing the position sensor





Remove
- the engine stabilizer brace between the suspension turrets
- the cable clamp on the engine stabilizer brace
Disconnect the pipe between the air cleaner (ACL) and the turbocharger at its upper end.
- the hoses from the hose bracket (at the left front of the engine)
- the hose bracket (at the left front of the engine)
Disconnect the connector.
Disconnect the wiring from the hooks on the bracket on the cylinder block (left front).
- the sensor.

Installing the position sensor





Install
- the new sensor. Tighten to 10 Nm
- the cable in the bracket on the cylinder block (left front)
- the cable in the hooks on the bracket (left front of the engine)
Connect the connector.
- the hoses in the bracket (at the left of the engine)
- the hose bracket (at the left front of the engine)
- the hoses in the bracket (at the left front of the engine)
- the tie straps on the bracket (at the left of the engine)
- the pipe between the air cleaner (ACL) and the turbocharger (TC)
- the engine stabilizer brace between the suspension turrets. Tighten the screws to the bodywork to50 Nm. Tighten the screw for the mounting for the engine stabilizer brace to80 Nm
- the cable clamp.