Switch, Hazard Warning Flashers

Switch, hazard warning signal flasher, replacing

Removal

Switch




- Insert a weatherstrip tool into the gap at the side of the ventilation housing. See the illustration. The arrows show the location of the mounting hooks
- Press the mounting hook up using a screwdriver. At the same time pry out the ventilation housing so that the hook releases.
Repeat for the other three mounting hooks so that the ventilation housing is released.




- Disconnect the connector
- Squeeze the mounting hooks together on the switch. Press the switch out.

Replace bulbs
- Remove switch
- Remove the bulb.

Installation

Bulb and light switch
- Place the switch in the hole in the ventilation housing and press into place
- Connect the connector
- Press the ventilation housing into position in the instrument panel.

Note! Check that the seal for the ventilation housing is intact. Replace if damaged.Check through the grille that the pipe for the ventilation housing aligns with the pipe from the climate control unit.