Description of Programmable Parameters, Customer Adaptation

Description Of Programmable Parameters, Customer Adaptation

Certain parameters of the climate control module can be read off and programmed using this function. The purpose of this programming is:
- to read the programmed parameters before replacing the control module. This is so the same parameters can be entered into the new control module.
- to adapt the function of the control module for the equipment levels of the car (passenger compartment ventilation filter, parking heater).
- to adapt the function of the control module to the requirements of the driver.

Passenger compartment ventilation filter compensation, status

Indicates the status for the activation of passenger compartment ventilation filter compensation.
OFF = Compensation not active.
ON = Compensation active (preset).

Blower fan run-on, status

Provides the status for activation of the blower fan run-on. The run-on dries the evaporator and prevents bad odors which may otherwise result from residual moisture in the system.
OFF = Run-on inactive.
ON = Run-on active (preset).

Blower fan speed, value

Allows the speed to be modified for the blower fan when the climate control system is in AUTO position. Modifying the parameters means that the climate control system either blows more or less air than the preprogrammed value, to correspond to the request of the driver.

Gives the voltage value for adaptation of the blower fan speed.
-1.0 - +1.0 V (0 V preset).

Setting for air distribution for the floor / defroster residual heat, value

Indicates the setting of the air distribution between the floor and defroster.
10/90 - 90/10% (70/30% preset).

Setting for air distribution for the floor / defroster parking heater, value

Indicates the setting of the air distribution between the floor and defroster.
10/90 - 90/10% (70/30% preset).