Checking the Ground Terminal for the Rear Electronic Module (REM)
Checking the ground terminal
Checking the ground terminal
- Ignition off
- Control module disconnected
- Switch off all equipment that takes power from the battery (courtesy lighting, radio etc).
Connect the breakout box.
Connect an ohmmeter between terminal #B21 on the breakout box and the battery negative terminal.
The ohmmeter should read approximately 0 ohm.
Other information
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box.
Is the value OK?
Yes - Fault Found
No - contact resistance and oxidation
-------------------------------------------------
Checking for open-circuits, contact resistance and oxidation
Check ground terminal 31/72 and the wiring connected to it. Check for an open-circuit. Check for contact resistance and oxidation.
Other information
- Checking wiring and terminals Checking Wiring And Terminals.
Continue - Verification
-------------------------------------------------
Verification
Verification
Verification
- Ignition off
- Control module disconnected
- Switch off all equipment that takes power from the battery (courtesy lighting, radio etc).
Connect an ohmmeter between terminal #B21 on the breakout box and the battery negative terminal.
The ohmmeter should read approximately 0 ohms.
Is the value OK?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - Fault Found
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
Attempt New Test - Checking the ground terminal
FAULT-TRACING FAILED - No Fault Found
-------------------------------------------------