Signal Too High

Signal too high

Initiating sun roof position

Note! Diagnostic trouble code (DTC) UEM-0058 is stored if the sun roof has been blocked at some point or incorrectly installed.

Try to adjust the sun roof so that it does not move at an angle or stick.
Check that nothing is located in the groove preventing the sun roof from being operated.

Other information
- Sun roof, adjusting Adjustments


Continue - Erasing diagnostic trouble code (DTC)

-------------------------------------------------

Erasing diagnostic trouble code (DTC)
Erase diagnostic trouble codes (DTCs).






Continue - Reading off diagnostic trouble codes (DTC)

-------------------------------------------------

Reading off diagnostic trouble codes (DTC)
Read off diagnostic trouble codes (DTCs). If the diagnostic trouble code (DTC) recurs, replace the sun roof.

Other information
- Sun roof, replacing Sun Roof, Replacing.






Continue - Fault Found

-------------------------------------------------