Circuit Error

Circuit error

Checking the wiring








- Ignition off, wait for 10 seconds.
- Disconnect the connector from the front right side impact airbag.
- Disconnect the connector for Supplemental restraint system module (SRS).

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical airbag. This could deploy the airbag!

Check connectors for damage to pins and connections.
Check the connectors. Check for loose connections. Check for contact resistance. Check for oxidation.
Also check other connectors and connections that connect cables between Supplemental restraint system module (SRS) and the airbag.
Check the cable. Check for loose connections. Check for an open-circuit. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.
Take readings between:
- The Supplemental restraint system module (SRS) #4C/60(60) and the connector to the side airbag, right front, #1.
- The Supplemental restraint system module (SRS) #3C/59(59) and the connector to the side airbag, right front, #2.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- Signal specification Signal Specification, Supplemental Restraint System Module (SRS)
- For further information, see the wiring diagram.
- Airbag module seat (SIPS), replacing Airbag Module Seat (SIPS), Replacing
- Control module SRS (supplemental restraint system), replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals
- Cable harness SRS system, repair Procedures


Continue - Replacing the control module

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking the wiring

-------------------------------------------------

Replacing the control module

Note! Troubleshooting on connectors and wiring must be done before the control module may be replaced.

Since the malfunction may result in internal functions in the Supplemental restraint system module (SRS) not working, the control module must be replaced.

Other information
- Control module SRS (supplemental restraint system), replacing Service and Repair







Continue - Fault-tracing information

-------------------------------------------------