Cable Fault

Cable fault. Permanent fault

Checking components and wiring




- Ignition off.

Caution! Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.

Check the cable between the SRS control module and the terminal on the side impact sensor connector according to the following:

for diagnostic trouble code (DTC) SRS-00B0,
front left side impact sensor terminals #8A (8) and #9A (9) and connector terminals #1 and #2.

for diagnostic trouble code (DTC) SRS-00B5,
front right side impact sensor terminals #8C (4) and #9C (5) and connector terminals #1 and #2.

for diagnostic trouble code (DTC) SRS-00BA,
rear left side impact sensor terminals #27A (27) and #28A (28) and connector terminals #1 and #2.

for diagnostic trouble code (DTC) SRS-00BF,
rear right side impact sensor terminals #27C (23) and #28C (24) and connector terminals #1 and #2.
check for a short-circuit to supply voltage. See Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault. Check for a short-circuit to ground. See Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.

Other information:
- To access and replace the SRS control module and connector, see Control module SRS (supplemental restraint system), replacing Service and Repair
- To access or replace the side impact sensor, see Collision sensor B and C-post, replacing Service and Repair
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- For other values, see Signal specification Signal Specification, Supplemental Restraint System Module (SRS).











Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking components and wiring

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------