Signal Too Low

Signal too low. Intermittent fault

Intermittent fault




- Ignition off.

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical airbag. This could deploy the airbag!

Caution! Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.

Check the connectors for:
- the airbag on the passenger side
- 4-pin
- the SRS control module.
check for contact resistance and oxidation. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for loose connections. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between SRS control module terminal #12B (40) and connector (green) terminal #1 on the passenger side airbag for a short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between SRS control module terminal #11B (39) and connector (green) terminal #3 on the passenger side airbag for a short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information:
- To access and replace the SRS control module and connector, see Control module SRS (supplemental restraint system), replacing Service and Repair
- To access the connector (green) for the passenger airbag, see Airbag passenger (SRS), replacing Airbag Passenger (SRS), Replacing
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- With the ignition off and the 4-pin connector and the connector for the control module disconnected, the resistance between terminals #1 and #2 on the 4-pin connector (SRS control module side) and ground should be infinite
- To replace the wiring, see Cable harness SRS system, repair Procedures
- For other values, see Signal specification Signal Specification, Supplemental Restraint System Module (SRS).














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Intermittent fault

FAULT FOUND - DONE

-------------------------------------------------