Internal Fault. Permanent Fault

Internal fault. Permanent fault

Replacing the component
Replace the RTI control module because an internal fault has been found.

Caution! A new RTI control module is delivered without software. The RTI control module must be programmed in order to function after replacement.

Other information:
- For information about programming and replacing the RTI control module, see Road traffic information module (RTI), replacing Service and Repair.


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Activate System test to test the GPS receiver functions. See System Test System Test.
Check that the GPS receiver functions.

Hint: Tell the customer that it may take 15 minutes of driving before the system is calibrated and functioning satisfactorily.





Is the GPS receiver OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Replacing the component

-------------------------------------------------