Internal Fault. Permanent Fault

Internal fault. Permanent fault

Replacing the component
Replace the RTI control module because an internal fault has been found.

Caution! A new RTI control module is delivered without software. The control module must be programmed in order to function after replacement.

Other information:
- For information about programming and replacing the RTI control module, see Road traffic information module (RTI), replacing Service and Repair.



Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Activate the System test to test the memory of the RTI control module. See System Test System Test.
Check if the RTI control module memory is OK or not. OK is displayed if the memory functions.

Hint: Tell the customer that it may take 15 minutes of driving before the system is calibrated and functioning satisfactorily.





Is the road traffic information (RTI) system functioning?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Replacing the component

-------------------------------------------------