Signal Missing. Permanent Fault

Signal missing. Permanent fault

Checking the wiring and component
Check that the "Rear windshield defroster" relay 2/82 is intact. Check that the relay is correctly installed.
Check that the main fuse 11E/5 and 11D/5 is intact.
Check the cable between main fuse 11E/5 and "Rear windshield defroster" relay 2/82 terminal #5. Check the cable between main fuse 11D/5 and "Rear windshield defroster" relay 2/82 terminal #1. Check the cable between rear electronic module terminal #D1 (terminal #B01) and "Rear windshield defroster" relay 2/82 terminal #2. Check these cables for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Check the relay terminal for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.
Try a new relay if no faults are found.

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters.
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box.
- When the relay is installed and not activated, the voltage at the relay guide should be 12 V.










Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring and component

FAULT-TRACING FAILED - No Fault Found

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.
Activate and de-activate the relay.





Is there a clicking noise from the relay when activated and deactivated?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------