Faulty Signal

Faulty signal

Calibrating the component





Note! If the vehicle is equipped with Four-C, calibration must be carried out via suspension module (SUM).

Calibrate the position sensor for the Bi-Xenon lamps.
- Someone must sit in the driver’s seat during calibration. The person must weigh at least 75 kg. Ensure that the vehicle is unladen and is on a flat surface.
- Ignition on
- Click on the VCT2000 symbol
- Calibrate the position sensor.






Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the rear axle sensor for the Xenon lamp is calibrated by clicking on the symbol for VCT2000.





Is the rear axle sensor calibrated?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Calibrating the component

-------------------------------------------------