Faulty Signal

Faulty signal

Checking status
Check if the fault is permanent or intermittent by turning the ignition key to position 0 and then to position 2. Fill with gas and check if the level on the fuel gauge changes.
The fault is permanent if the level does not change.
If the level changes it indicates that the fault has existed but is not active at present.

Continue - Replacing the component

-------------------------------------------------

Replacing the component
Replace the fuel level sensor.

Other information:
- To replace the fuel level sensor, see Replacing the level sensor for the gas tank Replacing the Level Sensor For the Gas Tank.


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Fill up with gas. Check that the level of the gas fuel gauge changes.

Does the fuel gauge change?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking status

-------------------------------------------------