Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition




Diagnostic trouble code (DTC) ECM-9300 is stored if the engine control module (ECM) registers a fault in the PWM signal from the clutch pedal position sensor when the ignition is switched on.

Substitute value
Cruise control switched off.

Possible source

Signal too high:
- Short-circuit to supply voltage in the signal cable
- Defective clutch pedal sensor.

Signal too low:
- Short-circuit to ground in the signal cable
- Defective clutch pedal sensor.

Faulty signal:
- Open-circuit in the signal cable
- Incorrectly installed clutch pedal sensor
- Defective clutch pedal sensor.

Fault symptom[s]
- Cruise control does not function at all.