Signal Missing

Signal missing

Checking the connector








- Ignition off
- Check the heated oxygen sensor (HO2S) connector. Check for contact resistance and oxidation
- Reinstall the components, reconnect the connectors etc.
- Start the engine. Allow the engine to idle.
Read off the status of the diagnostic trouble code (DTC) for the rear heated oxygen sensor (HO2S).
The text "NOT READY" is displayed if the diagnosis is running.

Other information
- For information about signals on 5 cylinder engines, see Signal specification Signal Description / Specification
- For information about signals on 6 cylinder engines, see Signal specification Signal Description / Specification
- To access or replace the heated oxygen sensor (HO2S), see Heated oxygen sensor (HO2S), replacing Heated Oxygen Sensor (HO2S), Replacing
- Checking wiring and terminals Checking Wiring And Terminals.













Is "FAULT NOT DETECTED" displayed?

Yes - Fault Found

No - Checking components and wiring

-------------------------------------------------

Checking components and wiring
Check the resistance of the heated oxygen sensor (HO2S) between terminals #1 and #2.
Check the signal cable between heated oxygen sensor (HO2S) terminal #2 and control module terminal #A6 (#A6). Check the power supply between system relay terminal #3 and heated oxygen sensor (HO2S) terminal #1. Check for an open-circuit.
Remedy as necessary.

Other information
- For information about signals on 5 cylinder engines, see Signal specification Signal Description / Specification
- For information about signals on 6 cylinder engines, see Signal specification Signal Description / Specification
- To connect the breakout box / access the control module, see Connecting the breakout box, B5244T5, B5254T2 Connecting the Breakout Box
- To access or replace the heated oxygen sensor (HO2S), see Heated oxygen sensor (HO2S), replacing Heated Oxygen Sensor (HO2S), Replacing
- For resistance values, see Component specifications Specifications
- Checking wiring and terminals Checking Wiring And Terminals.














Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reconnect connectors, reinstall components.
- Start the engine and let it idle.
Read off the rear heated oxygen sensor (HO2S) signal diagnostic trouble code (DTC) status.
The text NOT READY is displayed if the diagnosis is underway.









Is FAULT NOT REGISTERED displayed?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the connector

-------------------------------------------------