Faulty Signal - Intermittent Fault

Faulty signal. Intermittent fault

Checking connectors
Check boost pressure sensor connector for intermittent contact resistance, oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information
- To access/replace the boost pressure sensor, see Manifold absolute pressure (MAP) sensor, replacing Service and Repair.
- To access/replace the engine control module (ECM), see Engine control module (ECM), replacing Service and Repair.
- For information about signals, see Signal specification Signal Description / Specification.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking connectors

FAULT FOUND - DONE

-------------------------------------------------