Signal Too Low - Intermittent Fault

Signal too low. Intermittent fault

Checking wiring and connectors
Check the signal cable between control module terminal #A23 (#A23) and boost pressure sensor terminal 1. Check for an intermittent short-circuit to ground.

Other information
- To connect the breakout box / access the control module, see Connecting the breakout box, B5244T5, B5254T2 Connecting the Breakout Box
- To access or replace the boost pressure sensor, see Temperature and pressure sensor, replacing Service and Repair
- For information about signals on 5 cylinder engines, see Signal specification Signal Description / Specification
- For information about signals on 6 cylinder engines, see Signal specification Signal Description / Specification
- Checking wiring and terminals Checking Wiring And Terminals.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking wiring and connectors

FAULT FOUND - DONE

-------------------------------------------------