Signal Too High/Signal Too Low - Permanent Fault

Signal too high/signal too low. Permanent fault

Replacing component




- Ignition off.
The control module has registered an internal fault. Try a new control module according to Engine control module (ECM), replacing Service and Repair.

Note! When replacing a control module the new software must be programmed into the control module.





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Replacing component

FAULT FOUND - Fault Found

-------------------------------------------------