Signal Too High
Signal too high
Checking for permanent or intermittent faults
- Ignition on.
Select one door mirror and maneuver it.
Now select the other door mirror and try to maneuver it.
Can both the door mirrors be operated?
Yes - Intermittent fault
No - Replacing the component
-------------------------------------------------
Replacing the component
- Ignition off.
The driver door module (DDM) has registered an internal fault.
Note! A new control module is delivered without software. The control module must be programmed when it has been replaced.
Other information:
- For further information about programming and replacing the control module, see Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing.
After replacing the control module the window position must be initialized.
Ignition on.
Move the window to its upper limit position using manual control.
Initialize the window.
From model year 2003 inclusive, the window will lower approximately 10 centimeters and then close again during initialization.
Continue - Fault Found
-------------------------------------------------
Intermittent fault
Fault-tracing information
Fault-tracing information
Fault-tracing indicates that the control module had previously identified an intermittent fault, but that the fault is no longer present.
Continue - DONE
------------------------
DONE - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
FAULT FOUND - Fault Found
Attempt New Test - Checking for permanent or intermittent faults
-------------------------------------------------