Signal Too High

Signal too high

Checking for permanent or intermittent faults
Try to operate the door mirrors to their limit positions in all directions.

Can the door mirrors be operated in all directions?

Yes - Intermittent fault

No - Replacing the component

-------------------------------------------------

Replacing the component




- Ignition off.
The driver door module (DDM) has registered an internal fault.

Note! A new control module is delivered without software. The control module must be programmed when it has been replaced.

Other information:
- For further information about programming and replacing the control module, see Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing.
After replacing the control module the window position must be initialized.
Ignition on.
Move the window to its upper limit position using manual control.
Initialize the window.
From model year 2003 inclusive, the window will lower approximately 10 centimeters and then close again during initialization.






Continue - Fault Found

-------------------------------------------------

Intermittent fault




Fault-tracing information

Fault-tracing information
Fault-tracing indicates that the control module had previously identified an intermittent fault, but that the fault is no longer present.


Continue - DONE

------------------------

DONE - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking for permanent or intermittent faults

-------------------------------------------------