Stuck In the Active Position

Stuck in the active position

Checking for permanent or intermittent faults




- Ignition on.
Check if the child-proof button is working.

Is the child-proof button working?

Yes - Intermittent fault

No - Replacing the component

-------------------------------------------------

Replacing the component




- Ignition off.
The driver door module (DDM) has registered an internal fault.

Note! A new control module is delivered without software. The control module must be programmed when it has been replaced.

Other information:
- For further information about programming and replacing the control module, see Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing.




- Ignition on.
After replacing the control module the window position must be initialized.
Move the window to its upper limit position using manual control.
Initialize the window.
From model year 2003 inclusive, the window will lower approximately 10 centimeters and then close again during initialization


Continue - Fault Found

-------------------------------------------------

Intermittent fault
- The control module has previously registered an internal fault.
This may be because the child-proof button has been depressed for more than 10 seconds.
Fault-trace and erase the diagnostic trouble codes (DTCs). Switch the ignition on and off and read off diagnostic trouble codes (DTCs) again.
If the diagnostic trouble code (DTC) is not still stored, the fault is due to the above.


Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking for permanent or intermittent faults

FAULT FOUND - Fault Found

-------------------------------------------------