Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking the signal cable








- Ignition off
- Disconnect the connector from the central electronic module (CEM).

Hint: The signal cable goes from the Central electronic module (CEM) to ground via glass breakage circuit right and glass breakage circuit left.

Check the signal cable. Check for a short-circuit to ground.
Begin by measuring at the grounding point and then go backward along the circuit to find the defect.
Remedy as necessary.

Other information:
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Pinout Values and Diagnostic Parameters
- Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- For further information, see the wiring diagram.
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the signal cable

FAULT FOUND - Fault Found

-------------------------------------------------