Faulty Signal

Faulty signal

Checking the relay




- Ignition off.
Check that relay 2/23 is intact and correctly installed.
Check the relay terminals.
Remedy as necessary.

Other information
- To access / replace the relay, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing






Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect connectors, install components, etc.
- Start the engine.
Check that diagnostic trouble code status changes from permanent to intermittent.





Is the diagnostic trouble code status intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the relay

-------------------------------------------------