Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition





Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).

Diagnostic trouble code (DTC) BCM-0145 is stored If the brake control module (BCM) registers that the stability function operates for more than 15 seconds non-stop.

Substitute value
- Traction control is blocked
- Stability control is blocked
- Active yaw control is blocked.

Hint: For information about abbreviations, see Brake system, abbreviations Brake System, Abbreviations.

Possible source
- Incorrectly installed steering wheel
- Incorrect wheel alignment
- Loose or incorrectly installed active yaw control sensor
- Defective active yaw control sensor.

Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]
- The anti-spin warning lamp is lit (up to and including 2002 model year)
- General yellow warning lamp lit (from model year 2003 inclusive)
- Anti-spin does not function
- The stability control system does not function
- The traction control system does not function.