Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition





Note! The diagnostic trouble code (DTC) applies only to ABS systems equipped with dynamic stability and traction control (DSTC).

Brake pressure sensors 1 and 2 provide a signal with the brake system pressure to the brake control module (BCM). Diagnostic trouble code (DTC) BCM-0136 is stored if the control module registers that the signal from any of the pressure sensors is outside its permitted range.

Substitute value
- Traction control is blocked
- Stability control is blocked
- Active yaw control is blocked.

Hint: For information about abbreviations, see Brake system, abbreviations Brake System, Abbreviations.

Possible source
- Open-circuit in the ground lead
- Fault in the brake circuit
- Defective pressure sensor.

Fault symptom[s]
- The anti-spin warning lamp is lit (up to and including 2002 model year)
- General yellow warning lamp lit (from model year 2003 inclusive)
- Anti-spin does not function
- The stability control system does not function
- The traction control system does not function.