Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition





Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).

Diagnostic trouble code (DTC) BCM-0119 is stored if the brake control module (BCM) registers that the power supply to the active yaw control sensor is below 6 V ±0.5 V.

Substitute value
- Traction control is blocked
- Stability control is blocked
- Active yaw control is blocked.

Hint: For information about abbreviations, see Brake system, abbreviations Brake System, Abbreviations.

Possible source
- Contact resistance in the terminals on the active yaw control sensor
- Short-circuit to ground in the wiring
- Open-circuit in the wiring
- Internal fault in the active yaw control sensor

Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]
- The anti-spin warning lamp is lit (up to and including 2002 model year)
- General yellow warning lamp lit (from 2003)
- Anti-spin does not function
- The stability control system does not function
- The traction control system does not function.