Sensor Not Calibrated

Sensor not calibrated

Fault-tracing information

Hint: The diagnostic trouble code (DTC) may be stored when downloading software, in which case it only needs to be erased.

Note! Only erase the diagnostic trouble code (DTC) if it was stored when downloading software.




- Ignition on.
Erase diagnostic trouble codes (DTCs).






Continue - Calibrating the sensor

-------------------------------------------------

Calibrating the sensor




- Ignition on
- Calibrate the brake system.

Note! When calibrating, the car must be on a level surface. Do not touch the brake pedal.The accelerometer can only be calibrated on cars with All-wheel drive (AWD).

Caution! For the XC90, the yaw rate sensor and tilt sensor must also be calibrated.






Continue - Reading off the status of the diagnostic trouble code (DTC)

-------------------------------------------------

Reading off the status of the diagnostic trouble code (DTC)




- Ignition on
- Wait approximately 60 seconds
- Read off diagnostic trouble codes (DTCs).
If the status of the diagnostic trouble code (DTC) has changed from permanent to intermittent the fault is no longer active.
Try a new active yaw control sensor if the status of the diagnostic trouble code (DTC) is permanent.

Other information
- To replace the active yaw control sensor, see Active yaw control sensor, replacing Active Yaw Control Sensor, Replacing.





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - Fault Found

No - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, reinstall components etc.
- Test drive the car. See Test Drive Form (DSTC (dynamic stability and traction control) /brake control module), description Test Drive Form (DSTC (Dynamic Stability And Traction Control) /Brake Control Module), Description
- Ignition on.
Read off the status of the diagnostic trouble code (DTC).





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

PAPER - No Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Fault-tracing information

FAULT-TRACING FAILED - FAULT-TRACING FAILED

-------------------------------------------------