Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

STC or DSTC




Question

Question

Does the car have a DSTC system?

Yes - DSTC

No - STC

------------------------

STC - Intermittent fault

DSTC - DSTC

-------------------------------------------------

Intermittent fault
Check the control module and pump motor connector for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the wiring between the pump motor and the pump motor connector for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between the battery and control module terminal #47 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the ABS breakout box Pinout Values and Diagnostic Parameters.
- To disconnect the ABS control module connector, see Replacing the control module for ABS and dynamic stability and traction control (DSTC) Replacing the Control Module for ABS and Dynamic Stability and Traction Control (DSTC).
- For other values, see Signal specification, ABS / DSTC (dynamic stability and traction control) control module Signal Specification.










Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

DONE - DONE

FAULT FOUND - Fault Found

Attempt New Test - Intermittent fault

-------------------------------------------------

DSTC





Faulty signal. Intermittent fault

Intermittent fault
Check the control module and pump motor connector for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the wiring between the pump motor and the pump motor connector for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between the battery and control module terminal #47 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the ABS/DSTC breakout box Pinout Values and Diagnostic Parameters.
- To disconnect the ABS control module connector, see Replacing ABS / DSTC (dynamic stability and traction control) control module Replacing ABS / DSTC (Dynamic Stability and Traction Control) Control Module.
- For other values, see Signal specification, ABS / DSTC (dynamic stability and traction control) control module Signal Specification.










Continue - Fault-tracing information
DONE

------------------------

Fault-tracing information
Information
DONE - DONE

FAULT FOUND - Fault Found

Attempt New Test - Intermittent fault

------------------------

FAULT FOUND - Fault Found

DONE - DONE

-------------------------------------------------