BCM-0114

BCM-0114: Communications With The Active Yaw Control Sensor, Signal Missing
2GCondition





Note! The Diagnostic Trouble Code (DTC) applies only to cars with Dynamic Stability And Traction Control (DSTC).

Diagnostic Trouble Code (DTC) BCM-0114 is stored if the Brake Control Module (BCM) registers that the signal from the active yaw control sensor is missing or faulty.

Substitute value
- Traction control is blocked
- Stability control is blocked
- Active yaw control is blocked.

Hint: For information about abbreviations, Refer to Description and Operation.

Possible source
- Contact resistance in the terminals
- Open-circuit in the wiring between the Brake Control Module (BCM) and the active yaw control sensor
- The active yaw control sensor is not connected
- Internal fault in the active yaw control sensor.

Fault symptom[s]
- The anti-spin warning lamp is lit (up to and including 2002 model year)
- General yellow warning lamp lit (from model year 2003 inclusive)
- Anti-spin does not function
- The stability control system does not function
- The traction control system does not function.