Sunroof / Moonroof Module: Service and Repair

Replacing The Sunroof Control Module







- Close the sun roof.

CAUTION: Do not damage the headlining upholstery.

Remove:
- the roof lamp panel (lens, mounting screws, connector)
- the screw for the control module
- the control module. Carefully pry straight down and forwards. Remove the inner connector.

Installation
- Turn the cog (A) until the two white markings line up.
- Check the function.

Replacing the mechanism







Remove:
- the sun roof.
- the sun visor.
- wind deflector.
- mechanical cables.
- the gutter, 2 screws on each side. Press the mechanism outwards and pull it forwards.

CAUTION: Never pull the mechanism straight up.







- The mechanism is mounted in a guide cover at the rear.

Installing







Check all seals before installing as follows:
- Weatherstrip (1)
- Sealing tape for screw holes (2) between the guide rail for the mechanism and the sun roof base plate
- Apply new sealant to the rear of the guide rail (3) for the mechanism before installing it in the sun roof base plate. Check for leaks.
- The lead-in for the cable sleeve (4).

NOTE: If the guide rail has been removed it must be sealed using sealant P/N 686 275-9.