Procedures

Replacing The Oil Cooler

NOTE: As the illustrations in the information are used for different model years and/or models, certain variations may occur. However, the essential information in the illustrations is always correct.

Removing The Oil Cooler:







Raise the car.

Clamp both the oil cooler coolant hoses together with lock grip pliers.

Remove:
- the coolant hoses from the oil cooler.
- the oil cooler mounting screws.

Lift down the oil cooler.

Installing The Oil Cooler:







Use new seals.

The seals must be greased prior to installation.

Install:
- the oil cooler.
- Screw the 4 oil cooler screws into place.
- Tightening torque: 17 Nm (12 lb.ft).

- the coolant hoses.

Remove the lock grip pliers.

Check:
- the engine oil level.
- the coolant level.

Check For Leakage







- Start the engine and run it to operating temperature.
- Then check that there is no leakage.
- Check if the oil or coolant needs topping up.