Procedures

Tail Light Cluster, Replacement

Location of the lights
The illustration shows the locations of the lights on the RH side. The LH side is the same but mirror-reversed.







The lights have the following functions:
- 1+4 = Parking light/Tail light
- 2 = Reversing light
- 3 = Fog light, LH side only
- 5 = Direction indicator
- 6 = Brake light

Tail light, changing bulbs







- Ignition off.
- Open the cover in front of the tail light.
- Undo the wing nut and take out the lamp holder.
- Change the defective bulb.
- Fit in reverse order.

Check that all bulbs/lamps are intact and in working order.

Replacement of tail light cluster

NOTE: If a new tail light is to be fitted, the sleeves must be ground down 1.5 mm.







- Open the cover in front of the tail light.
- Undo the panel partly in front of the tail light.
- Unplug the connector for the tail light.
- Undo the four nuts securing the tail light.
- Pull the tail light straight out.

NOTE: Check the sealing and fit on reassembly.

Check that all bulbs/lamps are intact and in working order.