Internal Fault

Internal fault

Replacing the control module
The control module has registered an internal fault.

Caution! A new control module is delivered without software. The control module must be programmed in order to function after replacement.

For further information about programming and replacing the control module, see Replacing the gearbox control module (TCM) Replacing the Gearbox Control Module (TCM).





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reconnect connectors, reinstall components etc.
- Start the car.
- Depress the accelerator pedal (AP) slowly.
- Read off the current through the solenoid circuit.
The current should decrease as the accelerator pedal (AP) is depressed.





Does the current decrease?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the control module

-------------------------------------------------