Checking the Outside Temperature Sensor

Checking the outside temperature sensor

Checking the connectors








- Ignition off
- Remedy the connector on the right power door mirror. Check for contact resistance and oxidation.
In particular, check for any damage
- Reinstall the components, reconnect the connectors etc.
- Ignition on.
Check the outside temperature.

Other information:
- To access the connector for the power door mirror, see Door mirror, replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals.









Is the temperature within its permitted range?

Yes - Fault Found

No - Checking for a short-circuit

-------------------------------------------------

Checking for a short-circuit

If the control module is equipped with a 10-pin connector
Check the cable between right hand door control module #14A and power door mirror #1. Check for an open-circuit.
Check the cable between right hand door control module terminal #18A and power door mirror terminal #3. Check for a short-circuit to ground. Check for an open-circuit.

If the control module is equipped with a 16-pin connector
Check the cable between right hand door control module #14A and power door mirror #2. Check for an open-circuit.
Check the cable between right hand door control module terminal #18A and power door mirror terminal #3. Check for a short-circuit to ground. Check for an open-circuit.
Replace the cable if a fault is found.
Replace the outside temperature sensor if no fault is found.

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To access the connector for the power door mirror, see Door mirror, replacing Service and Repair
- To replace the outside temperature sensor, see Outside temperature sensor door mirror, replacing Outside Temperature Sensor Door Mirror, Replacing
- Checking wiring and terminals Checking Wiring And Terminals.













Continue - Fault Found

-------------------------------------------------