Checking Lamps and Needles

Checking lamps and needles

Activating lamps




- Ignition on
- Activate the system test procedures and check whether the relevant needle or lamp operates correctly. All needles must move from minimum to maximum and back again, and the lamps must flash (except for the MIL and the indicator light for the turn signal lamps).
The light level in the instrumentation is also checked.
All parts of the instrumentation flash.
Remedy as necessary

Other information:
- To replace the lamps, see Driver information module (DIM), replacing Driver Information Module (DIM), Replacing
- To replace the combined instrument panel see Driver information module (DIM), replacing Driver Information Module (DIM), Replacing.





Was a fault detected?

Yes - Fault Found

No - No Fault Found

-------------------------------------------------