Checking the Distance Covered For Service

Checking the distance covered for service

Selecting the instrument type
Select the appropriate alternative depending on whether the instrument is set for kilometres or miles. If the speedometer range is from 0-260 it is a kilometre instrument and if the range is from 0-160 it is a miles instrument.
1. Km
2. Miles.

Select desired alternative above.

1 - Programming the distance covered for service

2 - Programming the distance covered for service

-------------------------------------------------

Programming the distance covered for service




Programming the distance covered for service

Programming the distance covered for service (km)




- Ignition on.
There are three service parameter units which can be programmed. Using this parameter, the number of km (miles) is set which the car must cover before the SRL lamp switches on. (Service reminder lamp)
Choices can be made between 5000, 7500, 10000, 15000 or 20000 km (miles).
Read the programmed data.
If the service parameter is to be changed, mark the desired value in the scrolling list and start the programming.






Continue - DONE

------------------------

DONE - Fault Found

-------------------------------------------------

Programming the distance covered for service




Programming distance conditions for service

Programming distance conditions for service (miles)




- Ignition on.
There are three programmable service parameters. This parameter is used to set the number of miles a car can be driven before the Service Reminder Indicator (SRI) is lit. (Service reminder lamp)
2,500, 5,000, 6000, 7,500 10,000 or 12000 miles can be selected.
Read off the parameter that is programmed.
To change the service parameter, mark the desired value in the scrolling list and start programming.





Continue - DONE

------------------------

DONE - Fault Found

-------------------------------------------------