Replacing the Switch For the Seat Rail

Replacing the switch for the seat rail

Removal




- Remove the seat. See Replacing the seat Replacing the Seat
- Move the turn table to the dismount (maximum) position
- Remove the screws and nuts for the switch
- Separate the connector. Remove the switch.

Installation




- In reverse order.

Function test
- Lower the seat / turn table (to the driving position)
- Move the seat to the front or rear position
- Position the control unit so that the LED is visible
- Run the seat backwards or forwards until the LED on the control unit lights
- Repeat this function twice to ensure that the function is correct.

Note! The seat / turntable cannot be maneuvered if the LED on the control unit is not lit.