Checking the Warning Light

Checking the warning light

Checking the warning light




Programming daytime running lamps

Programming daytime running lamps
Three different daytime running light functions can be programmed:

1. Low beam in all switch positions except the parking light position (Flex zero)
Position light switch:
OFF:Parking and daytime running lamps or Xenon lamps are activated depending on the signal from the twilight sensor.
Parking lamps:Only parking lamps activated.
On:Parking and Xenon lamps are activated.

2. The light switch functioning on the basis of: off, parking light and low beam (Flex standard)
Position light switch:
OFF:Daytime running lamps are activated. If the twilight sensor registers insufficient light, all lighting is switched off (Xenon lamps are not activated).
Parking lamps:Only parking lamps activated.
On:Parking and Xenon lamps are activated.

3. Low beam always on regardless of the position of the light switch (Flex low)
Position light switch:
OFF:Parking and daytime running lamps or Xenon lamps are activated depending on the signal from the twilight sensor.
Parking lamps:Parking and Xenon lamps are activated.
On:Parking and Xenon lamps are activated.
It is essential that the legal requirements of each country are followed.

Note! It is not permitted to change this programming in the Canadian market.

Read off the programming by clicking on the VCT2000 symbol.
To change the setting, mark the desired value in the scrolling list and start programming.





Continue - Save the programmed value

------------------------

Save the programmed value
To ensure that the programmed information is stored, click on the VCT2000 symbol to force the entry.





Continue - DONE

------------------------

DONE - Fault Found

-------------------------------------------------