Activate Components/Functions

Activate components/functions




- Ignition on.
Activation can only be done when the vehicle ignition is on.
Activation is cut off if the ignition is switched off or vehicle communication is interrupted.
Activate components/functions by clicking on the symbol for VCT 2000.
For information on the various activations, see Diagnostic functions Diagnostic Functions.





Continue - DONE

Numeric Result 0 - Communication fault

-------------------------------------------------

Communication fault




Communication has been interrupted for one of the following reasons:
- The ignition is switched off
- VCT2000 disconnected from the data link connector (DLC)
- VCT2000 disconnected from the VIDA cart
- Communication problems in VIDA application or in car.
- No voltage in the data link connector (DLC).

Check therefore:
- That the control module power supply and ground terminal are fault-free.
- That the fuse for the data link connector (DLC) is intact.
- that the ignition is on
- that the battery voltage (system voltage) is normal (approximately 12 V).
If necessary a battery charger can be connected during the test.
For information about charge currents and the battery, see: Battery, charging Battery, Charging
- that VCT2000 is correctly connected to the VIDA cart and the data link connector (DLC)
- that VCT2000 and the wiring is fault-free.

Other information
- For information about fuse and terminal numbers, see the relevant Wiring Diagram.
Try to establish communication again or exit reading off diagnostic trouble codes (DTCs). Depending on the communication fault, select one of the following options.
1. Try again
2. Fault-trace more comprehensively for the communication problem that has occurred
3. Exit fault-tracing / Read off from the next system.





Which alternative is requested?

1 - Activate components/functions

2 - Checking communication

3 - FAILED

-------------------------------------------------

Checking communication
Some steps to ensure communication trouble-shooting.

Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Fault-tracing communication problems is now finished.

Do you want to try establishing communication again?

Yes - YES

No - NO

------------------------

YES - Activate components/functions

NO - FAILED

-------------------------------------------------