Connector Holder

Connector Holder













INTRODUCTION

NOTE: Read through the whole installation instruction before starting the work.

Connector holder







- Mark the hole for the connector bracket for drilling as illustrated.
- Pre-drill with a smaller drill bit. Enlarge the hole with a Dia. 6.5 mm (1/4")" drill bit.
- Remove any swarf. Rust-proof the edges of the holes.







- Take out the screw, washer, nut and bracket from the kit.
- Place the bracket over the drilled hole with the text (1) facing backwards. Mark out to cut off the corner of the bumper cover as illustrated.
- Cut off the corner.
- Fit the bracket (with the text (1) facing backwards), with the screw, washer and nut. Do not tighten the bracket yet.







- Place the connector on the bracket as illustrated.
- Adjust the position of the bracket with the connector and tighten the screw/nut correctly.