Signal Faulty

Signal faulty

Set-up
- The sunroof has lost its position and must be calibrated before it will work again.

Other information
- Sun roof module (SRM), calibrating Programming and Relearning


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.
Try to operate the sunroof automatically by pressing the switch down two stages.

Does the sunroof move automatically?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Set-up

FAULT-TRACING FAILED - No Fault Found

-------------------------------------------------