Chassis Number 26212 and Prior

Signal too high. Intermittent fault

Intermittent fault
Check the wiring between transmission control module (TCM) terminal #A49 (#A49) and transmission connector B terminal #3. Check the wiring between control module terminal #B7 (#A67) and transmission connector B terminal #6. Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Hint: Check the solenoid SLS by measuring the resistance between transmission connector B terminals #3 and #6. The resistance should be 5-5.6 ohms at 20°C.

Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box, B5244T5, B5254T2 Connecting the Breakout Box.
- To disconnect the transmission control module (TCM), see Transmission control module (TCM), replacing, B5244T5, AW55-50/51SN, B5254T2, AW55-50/51SN, B5254T2, AW50/51 AWD Service and Repair.
- To disconnect transmission connector B, see the relevant service procedure.
- For information about signals, see Signal description. Transmission control module (TCM), AW50/51 AWD, AW55-50/51SN Signal Description. Transmission Control Module (TCM).













Select Continue when the fault has been remedied.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - DONE

Attempt New Test - Intermittent fault

-------------------------------------------------