Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Checking the wiring and component
Check that the back-up (reversing) lamp relay (position 2/80) is correctly installed.
Check the relay terminal (2/80). Check for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters.
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box.
- To access the rear electronic module, see Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing.
- When the relay is installed and activated, the voltage at the relay guide should be 0 V.










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking the wiring and component

-------------------------------------------------